RAD Data comm 100 Especificações descarregar pdf (Página 67)

Egate-100 Ver. 4.0 Site Requirements and Prerequisites 2-1

Chapter 2

Installation and Setup

This chapter describes installation and setup procedures for the Egate-100 unit.

After installing the unit, refer to

Chapter 3

for operating instructions.

If a problem is encountered, refer to

Chapter 5

for test and diagnostic

instructions.

Egate-100 ships completely assembled. It is designed for installation as a desktop

unit or mounted in a 19-inch rack. For rack installation instructions, refer to the

documentation that comes with the RM kit.

Internal settings, adjustment, maintenance, or repairs must be performed only by

a skilled technician who is aware of the hazards involved.

Always observe standard safety precautions during installation, operation, and

maintenance of this product.

For your protection and to prevent possible damage if a fault condition such as a

lightning strike or contact with high voltage power lines occurs on the cables

connected to the equipment, Egate-100 must be properly grounded at all times.

Any interruption of the protective (grounding) connection inside or outside the

equipment, or disconnection of the protective ground terminal, can make this

equipment dangerous. Intentional interruption is prohibited.

2.1 Site Requirements and Prerequisites

AC-powered Egate-100 units should be installed within 1.5 meters (5 feet) of an

easily accessible and grounded AC outlet, capable of furnishing the required

supply voltage in the range of 100 to 240 VAC, at 50/60 Hz.

DC-powered Egate-100 units should be connected to -48 or -60 VDC mains in

accordance with the

DC Connection Supplement

Allow at least 90 cm (36 in) of frontal clearance for operator access. For

continuous product operation allow at least 10 cm of frontal clearance, and at

least 15 cm at rear of the unit, for cable connections and ventilation. For proper

ventilation, keep at least 2.5 cm clearance from the sides and top of the product.

The ambient operating temperature of Egate-100 is 0°

to 50° C (32° to 122°F), at

a relative humidity of up to 90%, non-condensing.

See also the sections describing connections of AC and DC mains at the beginning

of this manual.

Warning

Note

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 317 318

Sem comentários

RAD Data comm 100 Especificações Página 67