RAD Data comm 100 Especificações descarregar pdf (Página 267)

Installation and Operation Manual Chapter 7 Application Tutorial

Egate-100 Ver. 4.0 IP DSLAM and WiMAX Backhauling over SDH/SONET 7-23

Installing Egate-100

Egate-100 requires no special tools for installation. You need a screwdriver to

mount Egate-100 in a 19-inch rack. You need a screwdriver and drill to mount

Egate-100 on the wall.

Removing/installing the hot-swappable AC/DC units requires a flathead

screwdriver.

Egate-100 comes equipped with an appropriate (country or region dependent)

power cord to be connected from the power socket to the mains.

³ To install Egate-100:

1. Mount the unit.

2. Install fiber optic SFP modules.

3. Connect to channelized T3 equipment.

4. Connect to SDH/SONET equipment.

5. Connect to Gigabit Ethernet equipment.

6. Connect to management stations.

7. Connect to power.

After installing the unit, refer to the section

Configuring the Egate-100

for

configuration instructions.

Mounting the Unit

Egate-100 is designed for installation as a desktop unit or mounted in a rack.

• For rack-mounting instructions, refer to the installation kit manual.

• If Egate-100 is to be used as a desktop unit, place and secure the unit on a

stable, non-movable surface.

Installing Fiber Optic SFP Modules

Egate-100 uses SFP modules with LC fiber optic connectors that provide

hot-swappable industry-standard interfaces.

Third-party SFP optical transceivers must be agency-approved, complying with the

local laser safety regulations for Class 1 laser equipment.

³ To install the SFP modules:

1. Lock the wire latch of each SFP module by lifting it up until it clicks into place,

as illustrated in

Figure

7-30

Some SFP models have a plastic door instead of a wire latch.

Note

Warning

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 317 318

Sem comentários

RAD Data comm 100 Especificações Página 267