RAD Data comm 100 Especificações descarregar pdf (Página 285)

Installation and Operation Manual Chapter 7 Application Tutorial

Egate-100 Ver. 4.0 WiMAX Backhauling Opposite RICi-4T1 7-41

³ To install the SFP modules:

1. Lock the wire latch of each SFP module by lifting it up until it clicks into place,

as illustrated in

Figure

7-53

Some SFP models have a plastic door instead of a wire latch.

Figure

7-53. Locking the SFP Wire Latch

2. Carefully remove the dust covers from the SFP slot.

3. Insert the rear end of SFP into the socket, and push slowly backwards to

mate the connectors until the SFP clicks into place. If you feel resistance

before the connectors are fully mated, retract the SFP using the latch wire as

a pulling handle, and then repeat the procedure.

4. Remove the protective rubber caps from the SFP modules.

Connecting to Channelized T3 Equipment

The Egate-100 channelized T3 interface terminates in three pairs of

BNC connectors.

³ To connect the T3 interface:

• Connect Egate-100 to the T3 equipment using BNC cables terminated with

BNC connectors.

CONTROL

Egate-100

RDY

ALM

LINK

MNG-ETH

LIN K

ACT

GbE

ACT

LINK

DCE

CH1 CH2 CH3

Figure

7-54. T3 BNC Connectors

Connecting to SDH/SONET Equipment

The Egate-100 SDH/SONET network port terminates in a fiber optic interface with

LC connectors (SDH/SONET).

Note

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 317 318

Sem comentários

RAD Data comm 100 Especificações Página 285