RAD Data comm 100 Especificações descarregar pdf (Página 287)

Installation and Operation Manual Chapter 7 Application Tutorial

Egate-100 Ver. 4.0 WiMAX Backhauling Opposite RICi-4T1 7-43

Connecting to the Terminal

Egate-100 is connected to an ASCII terminal via a 9-pin D-type female connector

designated CONTROL. Refer to

Appendix A

for the connector pinout.

³ To connect to the terminal:

1. Connect the male 9-pin D-type connector of CBL-DB9F-DB9M-STR straight

cable available from RAD to the CONTROL connector.

2. Connect the other connector of the CBL-DB9F-DB9M-STR cable to an ASCII

terminal.

Terminal cables must have a frame ground connection. Use ungrounded cables

when connecting a supervisory terminal to a DC-powered unit with floating

ground. Using improper terminal cable may result in damage to supervisory

terminal port.

CONTROL

Egate-100

RDY

ALM

LIN K

MNG-ETH

LIN K

ACT

GbE

ACT

1 2

STM-1/OC-3STM-1/OC -3

LINK

SYNCSYNC

DCE

Figure

7-58: CONTROL Connector

Connecting to the Network Management Station

Egate-100 is connected to an NMS via an 8-pin RJ-45 connector designated

MNG ETH. Refer to

Appendix A

for the connector pinout.

³ To connect to an NMS:

• Connect Egate-100 to a hub or switch using a straight cable

Or;

• Connect Egate-100 to a network interface card using a cross cable.

When connecting Fast Ethernet cables longer than 30 meters (98 feet), it is

recommended to use shielded cables.

CONTROL

Egate-100

RDY

ALM

LIN K

MNG-ETH

LIN K

ACT

GbE

ACT

1 2

STM-1/OC-3STM-1/OC -3

LINK

SYNCSYNC

DCE

Figure

7-59: Fast Ethernet Management Connector

Note

Caution

1 2 ... 282 283 284 285 286 287 288 289 290 291 292 ... 317 318

Comentários a estes Manuais

Sem comentários

RAD Data comm 100 Especificações Página 287

Comentários a estes Manuais

Manuais e produtos relacionados com Redes RAD Data comm 100