RAD Data comm 100 Especificações descarregar pdf (Página 255)

Installation and Operation Manual Chapter 7 Application Tutorial

Egate-100 Ver. 4.0 User and Management Traffic Separated by VLAN 7-11

³ To configure the E1 ports for RICi-16E1/T1:

1. In the SDH/SONET Physical Port E1 menu, configure E1 port 20 as illustrated

Figure

7-14

2. Repeat the same configuration for E1 ports 21 to 35.

Egate-100

Main Menu> Configuration> Physical Layer> SDH/SONET> E1

1. Port Number [1-63] ... (20)

2. Administrative Status > (Up)

3. Frame Type > (CRC-4 Enable)

4. Idle Code [0-ff] ... (0)

5. Alarms > (Unmasked)

Please select item <1 to 5>

F - Forward Port; B - Backward Port; S - Save

ESC-prev.menu; !-main menu; &-exit

Figure

7-14. Configuring E1 Ports for RICi-16E1/T1

Setting Logical Layer Parameters

You must configure logical ports for the E1 ports, as specified in

Table

7-3

The following logical ports must be configured:

For RICi-E1/T1: Logical port 11, GFP (non-VCAT non-LCAS)

For RICi-8E1/T1: Logical ports 12 – 19 with PPP over HDLC, which are then

bound to logical port 20 with MLPPP protocol

For RICi-16E1/T1: Logical port 21 with VCG, which is then bound to logical port

22 with GFP (VCAT LCAS) protocol.

The logical ports are configured in the Logical Layer menu

(Main Menu>Configuration>Logical Layer).

Table

7-3. E1 Port Specifications

Unit/Interface E1 port

numbers

Framing type Logical port

numbers

Protocol Bridge port

number

RICi-E1/T1 11 CRC 4 enabled 11 GFP (non-VCAT non-LCAS) 101

RICi-8E1/T1 12 – 19 Unframed 12 – 19 PPPoHDLC

20 MLPPP, bound to logical

ports 12 – 19

102, bound to

MLPPP port

RICi-16E1/T1 20 – 35

CRC 4 enabled 21 VCG

22 GFP (VCAT LCAS), bound

to logical port 21

103, bound to

GFP port

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 317 318

Comentários a estes Manuais

Sem comentários

RAD Data comm 100 Especificações Página 255

Comentários a estes Manuais

Manuais e produtos relacionados com Redes RAD Data comm 100