RAD Data comm 100 Especificações descarregar pdf (Página 128)

Chapter 4 Configuration Installation and Operation Manual

4-36 Configuring Egate-100 for Operation Egate-100 Ver. 4.0

Egate-100

Configuration> System> Syslog >Server Parameters

Server Sequence ... (1)

Server Access > (Disable)

1. Server IP Address ... (190.72.140.100)

2. Server UDP Port[1-65535] ... (514)

S-Save

ESC-Previous menu; !-Main menu; &-Exit

Figure

4-35. Syslog Server Parameters Menu

Table

4-13. Syslog Server Parameters

Parameter Description Possible Values

Server

Sequence

Server sequence number

Default: 1

1–5

Server Access Server access parameter

Default: Disabled

Enabled

Disabled

Server IP

Address

IP address of the Syslog server to which the

event logs are sent.

0.0.0.0 –

255.255.255.255

Server UDP Port The UDP port of the Syslog server.

Default: 514

Note: The port cannot be changed when the

logging status is enabled.

1–65535

Setting Physical Layer Parameters

Egate-100 has SDH/SONET or Channelized T3 ports, depending upon installation

option, as well as Gigabit Ethernet ports. The SDH/SONET, T3, and Gigabit

Ethernet configuration menus are accessed from the Physical Layer menu.

If you need to make a change to the configuration of SDH/SONET or T3 physical

ports, you must first clear any mapping of these ports to the logical ports. The

Egate-100 device provides a read-only mapping table that describes the

SDH/SONET tributary mapping to physical E1/T1 ports (see

Figure

4-47

and

Figure

4-48

Configuring the SDH/SONET Ports

³ To configure SDH/SONET ports:

1. Navigate to Main Menu > Configuration > Physical Layer.

The Physical Layer menu appears as illustrated in

Figure

4-36

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 317 318

Comentários a estes Manuais

Sem comentários

RAD Data comm 100 Especificações Página 128

Comentários a estes Manuais

Manuais e produtos relacionados com Redes RAD Data comm 100