RAD Data comm 100 Especificações descarregar pdf (Página 246)

Chapter 7 Application Tutorial Installation and Operation Manual

7-2 User and Management Traffic Separated by VLAN Egate-100 Ver. 4.0

Equipment List

The following is a list of equipment needed to set up this application:

• Egate-100

• ETX-202A NTU, ICi-E1/T1, RICi-8E1/T1, RICi-16E1/T1

• Network management station

• Network connectors (see

Table

7-1

Table

7-1. Required Connectors

Interface Cable/Connector

Control port Straight RS-232/V.24 cable with DB-9 male connector

for ASCII terminal

Fast Ethernet management

port

RJ-45, 8-pin connector

SDH/SONET interfaces LC (SFP) fiber optic connector

Channelized T3 interface BNC connector

Gigabit Ethernet interfaces Electrical: RJ-45, 8-pin connector

Optical: LC (SFP) fiber optic connector

Installing Egate-100

Egate-100 requires no special tools for installation. You need a screwdriver to

mount Egate-100 in a 19-inch rack. You need a screwdriver and drill to mount

Egate-100 on the wall.

Removing/installing the hot-swappable AC/DC units requires a flathead

screwdriver.

Egate-100 comes equipped with an appropriate (country or region dependent)

power cord to be connected from the power socket to the mains.

Refer to

Table

7-1

to determine which cables and connectors are required for

installation.

³ To install Egate-100:

1. Mount the unit.

2. Install fiber optic SFP modules.

3. Connect to channelized T3 equipment.

4. Connect to SDH/SONET equipment.

5. Connect to Gigabit Ethernet equipment.

6. Connect to management stations.

7. Connect to power.

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 317 318

Comentários a estes Manuais

Sem comentários

RAD Data comm 100 Especificações Página 246

Comentários a estes Manuais

Manuais e produtos relacionados com Redes RAD Data comm 100