RAD Data comm 100 Especificações descarregar pdf (Página 203)

Installation and Operation Manual Chapter 4 Configuration

Egate-100 Ver. 4.0 Additional Tasks 4-111

Parameter Description Possible Values

Stratum This parameter indicates the quality of the NTP

server. The lower the number, the higher the

quality, therefore if there are multiple servers

you should select the server with the lowest

stratum as the preferred NTP server.

Note: If no timestamp has been received from

the server, or if counter overflow occurs in the

parameter Received ddd:hh:mm:ss Ago, ‘--‘ is

displayed.

Last Timestamp Last date and time received from the NTP

server, in format:

dd-mm-yyyy

hh:mm:ss

Note: If no timestamp has been received from

the server, or if counter overflow occurs in the

parameter Received ddd:hh:mm:ss Ago, ‘--‘ is

displayed.

Received

ddd:hh:mm:ss Ago

Displays elapsed time since date and time were

received from the NTP server, in format

ddd:hh:mm:ss

Note: If no timestamp has been received from

the server, or if counter overflow occurs in this

paramete then ‘--‘ is displayed.

Resetting Egate-100

Egate-100 supports two types of reset:

• Reset all parameters to their factory defaults

• Restart the device.

Resetting to Factory Defaults

You can reset Egate-100 to its default configuration settings. For a complete list

of the configuration defaults, refer to

Chapter 3

³ To reset Egate-100 to the default settings:

1. Navigate to Main Menu > System > Factory Defaults.

Egate-100 displays the following message:

The device parameters will be set to defaults. Unit must

be reset. Do you want to proceed? (Y/N)

2. Type Y to confirm your request.

The device enters user mode, where you cannot configure parameters.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 317 318

Comentários a estes Manuais

Sem comentários

RAD Data comm 100 Especificações Página 203

Comentários a estes Manuais

Manuais e produtos relacionados com Redes RAD Data comm 100