RAD Data comm 100 Especificações descarregar pdf (Página 288)

Chapter 7 Application Tutorial Installation and Operation Manual

7-44 WiMAX Backhauling Opposite RICi-4T1 Egate-100 Ver. 4.0

Connecting to Power

Egate-100 can be ordered with either AC power or DC power (single or dual

power supply).

Connecting to AC Power

AC power is supplied to Egate-100 via a standard 3-prong plug.

AC power should be supplied through the 1.5m (5 ft) standard power cable

terminated by a 3-prong plug. The cable is provided with the unit.

Before connecting or disconnecting any communication cable, the unit must be

grounded by connecting its power cord to a power outlet with a ground terminal,

and by connecting the ground terminal on the panel (if provided) to a protective

ground.

Interrupting the protective (ground) conductor inside or outside the unit, or

disconnecting the protective ground terminal may render this unit dangerous.

Intentional interruption is prohibited.

If the Egate-100 unit is equipped with two hot-swappable power supplies,

DO NOT install AC and DC power supplies together in the same unit.

³ To connect AC power:

1. Verify that the AC outlet is grounded properly. Ensure that the supply voltage

is in the range 100 VAC to 240 VAC

2. Connect the power cable to a power connector on the Egate-100 front panel.

3. Connect the power cable to the mains.

The unit turns on automatically.

Connecting to DC Power

³ To connect DC power:

• Refer to the DC power supply connection supplement, located on the

Technical Documentation CD or at the end of this manual. Also, refer to the

safety instructions at the beginning of this document.

Configuring Egate-100

The Egate-100 unit is initially configured via an ASCII terminal connection. The

configuration procedure is divided into the following stages:

•

Setting System Parameters

•

Setting Ethernet Parameters

•

Setting SDH/SONET Parameters

•

Setting Logical Layer Parameters

•

Setting Bridge Parameters

Warning

1 2 ... 283 284 285 286 287 288 289 290 291 292 293 ... 317 318

Comentários a estes Manuais

Sem comentários

RAD Data comm 100 Especificações Página 288

Comentários a estes Manuais

Manuais e produtos relacionados com Redes RAD Data comm 100