RAD Data comm 100 Especificações descarregar pdf (Página 26)

Quick Start Guide Installation and Operation Manual

 Frame Type: Specify whether mode of operation is SDH or SONET

 Administrative Status: Specify whether the network port is to be used.

 Tx Clock: Select the source of the system clock: Internal or Loopback

Timing.

 Alarms: Specify whether to mask or unmask the alarms.

 E1/T1: Specify the E1/T1 frame mode and port parameters.

³ To configure channelized T3 interfaces:

1. In the T3 menu (Main > Configuration > Physical Layer > T3), configure the

following parameters:

 Administrative Status: Specify whether the network port is to be used.

 Tx Clock: Select the source of the system clock: Internal or Loopback

Timing.

 Line Length: Specify long or short T3 line.

 Alarms: Specify whether to mask or unmask the alarms.

2. Navigate to T1 (Main > Configuration > Physical Layer > T3 > T1) and

configure the mapped T1 channel parameters for each T3 port.

³ To configure logical ports:

• In the Logical Ports menu (Main > Configuration > Logical Layer), define and

configure the required logical ports, including the selection of the protocol

(HDLC, PPP over HDLC, MLPPP, GFP, or VCG).

³ To configure bridge ports:

1. In the Bridge menu (Main > Configuration > Applications > Bridge), configure

the necessary bridge parameters:

 VLAN Mode (VLAN-aware or VLAN-unaware): Specify whether bridge

operates in VLAN-aware or VLAN-unaware mode.

 Aging Time: Specify how long to keep MAC table entry without erasing it,

if no frame is received with the MAC.

 Split Horizon: Specify whether bridge operates with split horizon feature,

to prevent switching packets between bridge ports bound to logical ports

 VLAN Ethertype: Specify value used to identify and manipulate VLAN

frames

 Loop Detection: Specify whether loop detection is enabled.

2. In the Bridge Port menu (Main > Configuration > Applications > Bridge>

Bridge Ports), define the relevant bridge ports.

³ To enable Gigabit Ethernet port redundancy:

• In the Ethernet aggregation menu (Main > Configuration > System >

Protection > Ethernet Aggregation), enable Ethernet Aggregation.

To enable Ethernet aggregation, both Gigabit Ethernet links must be set to Full

Duplex mode at the same line speed, and autonegotiation must be enabled.

Note

6 Configuring Egate-100 Egate-100 Ver. 4.0

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 317 318

Sem comentários

RAD Data comm 100 Especificações Página 26