RAD Data comm ASMI-450 Manual do Utilizador descarregar pdf (Página 88)

Chapter 4 RADview-HPOV System Functions RADview-HPOV/ATM User’s Manual

4-30 TFTP File Transfer

Associating Profiles to Nodes

You can add an agent to the agent list in the Operation tab by the one of the

following methods:

• Add Agent directly from the HPOV/PC SNMPc Map

• Add Agent dialog box.

The Add from Map method is preferred because the Community, Timeout, and

Retries of the SNMP node are obtained automatically from the map. This is faster

and more accurate since there is no need for you to define them.



To add an agent from the map to the list in the Operation tab:

1. Click <Add from Map>.

The Add Agent from Map dialog box appears (see Figure 4-26). As

RADview polls all the agents, it lists it on the dialog box. When it finished,

the status bar at the bottom of the screen says Ready.

2. Highlight the Name–IP Address–Product of the SNMP node to be added.

3. Press <Apply>.

The SNMP node is added to the list in the Operation tab.

The Node Name column in Operation tab displays the Node Name as it was, when

Add from Map was performed (for HPOV, Selection Name). If afterwards user

changes the Selection Name/Node Name of this node in the map, the Node name

in SWDL application will NOT be updated (implementation problems).

Figure 4-26. Add Agents from Map Dialog Box

Note

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 165 166

Sem comentários

RAD Data comm ASMI-450 Manual do Utilizador Página 88