RAD Data comm ASMI-450 Manual do Utilizador descarregar pdf (Página 50)

Chapter 3 Configuration Management User's Manual

3-28 Setting Operational Parameters LRS-24 RADview/TDM

Figure 3-25. Ports Configuration Dialog Box – E1 Tab

3. Fill in the fields, as described in

Table 3-6

, which lists some of the Ports

Configuration dialog box parameters. For descriptions of additional fields

relevant to specific modem types, see the following section

4. Click <Set> to implement the changes. ([Set] is disabled for Interface Type

(IR) = NO IR.

Configuring Modem Port Parameters

To configure the port parameters, set the Modem Mode as Master. If the Modem

Mode is set to Slave, the ports configuration parameters are not configurable.)

Viewing and Modifying the Modem Mode is not applicable for ASMi-51CD,

ASMi-51-CQ, ASMi-51 or ASMi-52CD/CD4W/CQ units. Modem Mode does not work

for ASMi-50, versions≥ 0.8x.

For instructions on how to set the modem mode, refer to

Viewing and Modifying

the Modem Mode

General limitations for various Ports Configuration fields are as follows:

• For the DTE Rate field, RADview checks the selectable values for both the

near and far ends. Only the common values are displayed in the dialog boxes

of both modems. If no common values are found, then the selectable list is

available for each modem separately.

Note

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 159 160

Sem comentários

RAD Data comm ASMI-450 Manual do Utilizador Página 50