RAD Data comm ASMI-450 Manual do Utilizador descarregar pdf (Página 48)

Chapter 3 Configuration Management User's Manual

3-26 Setting Operational Parameters LRS-24 RADview/TDM

Parameter Possible Values / Remarks

Hub Id Hex characters identifying the hub

Enabled only if the far-end modem is an LRS-24 card

Read-only

Slot The far-end modem slot number, I/O-1 to I/O-12

Enabled only if the far-end modem is an LRS-24 card

Read-only

I-Type Yes or No

Enabled only for FOMi-40 and FOMi-E1/T1 modem

Read-only

Comments User may type any freeform text

When configuring a card opposite a card, the System Information dialog box

sometimes displays incorrect values for the fields, Far-End Hub ID and Far-End IP

Address. This problem exists for the following modems: FOMi-E1/T1C,

FOMi-E1/T1CD (modem #2), ASMi-24, ASMi-31, ASMi-50CD (modem #2).

Viewing Port Configuration

 To view the port configuration:

1. In the Zoom view, select the modem (near end or far end), right-click and

select Configuration > Ports Config.

(If there is communication between Near-End and Far-End modems, then

NMS gets the value of the Interface Type (IR) for both Near-End and Far-

End modems.)

2. Click the tab of the port to configure.

Note

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 159 160

Sem comentários

RAD Data comm ASMI-450 Manual do Utilizador Página 48