RAD Data comm Megaplex-2100 Informações Técnicas descarregar pdf (Página 146)

Chapter 2 Agent Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual

Figure 2-47. Software Configuration ML–IP (Int. Port)

Table 2-35. Software Configuration –ML–IP (Internal Port)

Parameter Possible Values / Remarks

Connect No, Yes

CAS Enable Enables CAS

Enable (checked), Disable (unchecked)

Routing Protocol None, RIP2, Proprietary RIP

OOS Signal State of the signaling bits when the link is in out-of-service (OOS) state:

Forced Idle – Signaling bits A and B are idle when the link is in out-of-service

state. In addition, if the line type is ESF, signaling bits C and D are also idle.

Forced Busy - Signaling bits A and B are busy when the link is in out-of-service

state. In addition, if the line type is ESF, signaling bits C and D are also busy.

Busy Idle - Signaling bits A and B are busy for 2.5 seconds, then become idle

until the out-of-service state ends. In addition, if the line type is ESF, signaling bits

C and D are idle for 2.5 seconds before switching to busy state.

Idle Busy - Signaling bits A and B are idle for 2.5 seconds, then become busy

until the out-of-service state ends. In addition, if the line type is ESF, signaling bits

C and D are busy for 2.5 seconds before switching to idle state.

Signalin Profile 1, 2, 3, 4, 5

IP Address IP Address

IP Mask IP Mask

2-58 Agent Port Level Operations

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 167 168

Sem comentários

RAD Data comm Megaplex-2100 Informações Técnicas Página 146