RAD Data comm Megaplex-2100 Informações Técnicas descarregar pdf (Página 124)

Chapter 2 Agent Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual

2. Click <Apply>.

Defining Scope of Alarm Reports

Using the Reports command, you can define the scope, type and severity of alarm

reports that you will receive at the network management station.



To define an alarm report:

1. In the Fault menu, click Alarms, followed by Configuration and Reports…

The Alarm Report dialog box appears.

2. Set the desired severity level for each report: Event, Warning, Minor, Major,

or Critical.

3. Click <Set>.

Figure 2-33. Alarm Report Dialog Box

Table 2-18. Alarm Report Parameters

Parameter Possible Values / Remarks

Trap Define whether you want to receive traps for all alarms or for only those alarms of at

least a certain severity.

Alarm On Severity - Minimum level of severity required for sending a trap to the

network management station. Trap severity must be equal or higher than buffer severity.

Alarm Off Severity - Maximum level of severity allowed for a trap not to be sent to the

network management station.

2-36 Megaplex Level Fault Operations

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 167 168

Sem comentários

RAD Data comm Megaplex-2100 Informações Técnicas Página 124