RAD Data comm FOM-E3 Especificações descarregar pdf (Página 54)

Chapter 4 Configuration Installation and Operation Manual

4-14 Configuring for Operation RICi-E3, RICi-T3 Ver. 1.0

Configuring the T3 Port

RICi-T3 includes a T3 port. You can configure its parameters at the physical level

as follows:

 To configure the T3 port:

1. From the Physical Ports menu, select T3.

The T3 menu appears as illustrated in

Figure 4-11

RICi-T3

Configuration > Physical Ports >T3

1. Administrative Status (Up)

2. Framing (M23)

3. Tx Clock (LBT)

4. Line Build Out (Up to 225ft)

5. Protocol (LAPS)

ESC-prev menu; !-main menu; &-exit 1 user(s)

Figure 4-11. T3 Menu

2. From the T3 menu, configure the following:

 Administrative Status

 Up – the network port is enabled

 Down – the network port is disabled.

 Framing. Specifies the framing type

 M23

 C-bit.

 Tx Clock. Specifies the clock

 Internal Clock

 LBT.

 Line Build Out for Line Mode = DSU. The length of a cable in feet between

T3 port connector and the network access point

 Up to 225 feet – 0 to 225 ft

 Over 225 feet – 225 ft and further.

 Protocol. Specifies the encapsulation

 HDLC

 LAPS.

3. Select Save to complete the user T3 port configuration.

The selected value shows in the T3 Port configuration menu.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 101 102

Sem comentários

RAD Data comm FOM-E3 Especificações Página 54