RAD Data comm FOM-E3 Especificações descarregar pdf (Página 12)

Quick Start Guide Installation and Operation Manual

2 Configuring RICi-E3, RICi-T3 RICi-E3, RICi-T3 Ver. 1.0

2. Configuring RICi-E3, RICi-T3

Configure RICi-E3, RICi-T3 to the desired operation mode via an ASCII terminal

connected to the rear panel CONTROL port. Alternatively, you can manage

RICi-E3, RICi-T3 over Telnet, a PC running a Web browsing application, or SNMP via

the Ethernet or E3 port.

Remote management requires assigning an IP address.

Starting a Terminal Session

 To start a terminal session:

1. Connect an ASCII terminal to the CONTROL port at the front panel. The

default settings are as follows:

 Baud Rate: 115,200 bps

 Data Bits: 8

 Parity: None

 Stop Bits: 1

 Flow Control: None.

2. To optimize the view of the system menus, do the following:

 Set the terminal emulator to VT100.

 If you are using HyperTerminal, set the terminal mode to the 132-column

mode.

3. Enter your user name and password and proceed with the management

session.

The RICi-E3, RICi-T3 default user name is su (lower case). The default password is

1234.

Note

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 101 102

Sem comentários

RAD Data comm FOM-E3 Especificações Página 12