Rad-data-comm ASMI-450 Manual do Utilizador descarregar pdf (Página 86)

ASMi-450 Control from the Control Port

4-28 ASMi-450 Installation and Operation Manual

• When you see the correct and complete command in the echo line, press

<CR> to execute the command. The ASMi-450 will process the

command and display the appropriate response.

At the end of the command execution, the ASMi-450 displays the

current time and date, and then provides a new prompt for the next

command line.

• If you changed your mind, and want to abort the command, press

BREAK or CTRL-C. You will again receive the prompt, so you can

enter another command.

Note

You can also use BREAK or CTRL+C to stop automatic repetition of

commands sent with the /R option.

2. If your command is not correct, the ASMi-450 will not execute it, but will

echo again the command, with a bad command message in the following

line. Type again the correct command.

3. If the terminal screen fills up during the exchange with the ASMi-450, you

will see the message:

HIT ANY KEY TO CONTINUE

After pressing any key except BREAK, the terminal scrolls to the next page.

Ending a Control

Session

1. To end the control session, type:

EXIT

2. The ASMi-450 prompt will disappear. Now you can control the ASMi-450

from its front panel.

Note

A control session may also be terminated by the ASMi-450 if the idle disconnect

time-out is enabled, or when the DTR line switches to the inactive (OFF) state.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 116 117

Sem comentários

Rad-data-comm ASMI-450 Manual do Utilizador Página 86