RAD Data comm FCD-X21 Manual de Instalação descarregar pdf (Página 195)

Installation and Operation Manual Appendix D Command Language

FCD-E1 Supervisory Terminal Commands D-33

Syntax

DEF TERM {‘terminal type’}

Use

1. To reset the terminal control codes to 0, type:

DEF TERM<Enter>

2. To select the control codes for one of the above-mentioned types, type:

DEF TERM ‘terminal type’<Enter>

where ‘terminal type’ stands for TV920, VT52, VT100, Freedom100 or

Freedom220.

3. Press <Enter> again to end.

DSP AGENT

Purpose

Display the FCD-E1 agent parameters.

Syntax

DSP AGENT

Use

To display the agent parameters, type:

DSP AGENT

You will see the SNMP parameters data form. A typical form is shown

below:

AGENT PARAMETERS

--------------------

IP ADDRESS IS : = XXX.XXX.XXX.XXX

MAC ADDRESS IS : = XXX.XXX.XXX.XXX.XXX.XXX

Refer to the DEF AGENT on page D-15 for an explanation of the information

displayed by this command.

DSP ALM

Purpose

Display the contents of the alarm buffer. This buffer can contain up to 100 alarms.

Syntax

DSP ALM [Option]

Use

1. To display the complete contents of the buffer, type:

DSP ALM<Enter>

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 223 224

Sem comentários

RAD Data comm FCD-X21 Manual de Instalação Página 195