RAD Data comm FCD-X21 Manual de Instalação descarregar pdf (Página 105)

Installation and Operation Manual Chapter 4 Configuration

FCD-E1 Supervision Terminal Operating Instructions 4-23

2. If your command is not correct, the FCD-E1 will not execute it, but will echo

again the command, with a BAD COMMAND message in the following line.

Type again the correct command.

3. If the terminal screen fills up during the exchange with the FCD-E1, you will

see the message:

HIT ANY KEY TO CONTINUE

After pressing any key except BREAK, the terminal scrolls to the next page.

Ending a Control Session

1. To end the control session, type:

EXIT

The command used to end Telnet sessions is BYE.

2. The FCD-E1 prompt will disappear. Now you can control the FCD-E1 from its

front panel.

A control session may also be terminated by the FCD-E1 if the idle disconnect

time-out is enabled, or when the DTR line switches to the inactive (OFF) state.

Note

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 223 224

Sem comentários

RAD Data comm FCD-X21 Manual de Instalação Página 105