RAD Data comm E1/T1 Manual do Utilizador descarregar pdf (Página 140)

Chapter 5 Setup Menu FCD-IPM Installation and Operation Manual

5-50 Interface Parameters Menu

T1 ALARMS FILTER (Device name - FCD-IPM)

----------------

1. Frame slip : [Unmasked]

2. BPV error : [Unmasked]

3. Execive BPV : [Unmasked]

4. Execive error ratio: [Unmasked]

5. Signal loss : [Unmasked]

6. Yellow alarm : [Unmasked]

7. Red alarm : [Unmasked]

8. AIS red alarm : [Unmasked]

9. AIS : [Unmasked]

10. Network loop - LLB : [Unmasked]

11. Network loop - PLB : [Unmasked]

ESC - Return to previous menu

Choose one of the above:

Figure 5-55. T1 Alarms Filter Menu

Advanced Setup Menu

Select this option to configure the management via a dedicated time slot.

This feature enables management of the FCD-IPM by configuring a specific time

slot, of type MNGMNT. A new T1 management link is then created and assigned

with a unique host IP address, which is different from the LAN/WAN IP addresses

defined in other screens. The management host IP address is used for SNMP,

Telnet, TFTP software download or ping.

The management link must be of the IP router type, and is available to IP traffic

only.

Dedicated Time Slot Management Status

Select this parameter to enable management via the dedicated time slot. By

default, this is disabled.

Management Time Slot Number

Select this parameter to set the specific time slot number for management.

Management Host IP Address

Select this parameter to set a unique IP address.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 223 224

Sem comentários

RAD Data comm E1/T1 Manual do Utilizador Página 140