RAD Data comm IPmux-1E Especificações descarregar pdf (Página 114)

Appendix E Parameters and Screens IPmux-1/1E Installation and Operation Manual

E-16 IPmux-1 E1/T1 Configuration

Table E-11. E1 Physical Layer Configuration Parameters (Cont.)

Parameter Possible Values Remarks

Signaling mode

CAS enable

CAS disable

The E1 framer is set to CAS MF mode and the operation mode

to fractional with CAS mode.

CAS MF will not be set in the E1 framer and the operation

mode will be configured to fractional mode.

Note: This field will not appear if “unframed” is selected in the

Line Type field.

Default value: CAS Enable

Byte Code 00 to FF Conditioning pattern can be applied to timeslots toward the IP

path when loss of signal, loss of frame or AIS is detected at the

E1 line. Conditioning pattern can also be applied to timeslots

toward the E1 line when packet receive buffer overrun or

under-run occurs. In Unframed mode, conditioning state will

result in AIS transmission. This will be applied when a LOS is

detected at E1 line, or when packet receive buffer overrun or

under run occurs.

Note: This field will not appear if “unframed” is selected in the

Channel Type field.

Default Value: FF

4 bit code 1 to F The ABCD conditioning pattern can be applied toward the IP

path when loss of signal, loss of frame, or AIS is detected at the

E1 line. Conditioning pattern can also be applied toward the

E1 line when packet receive buffer overrun or underrun occur.

Note: This field will not appear if “Unframed” is selected in the

Channel Type field.

Default Value: 1

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610

www.bestdatasource.com

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 142 143

Sem comentários

RAD Data comm IPmux-1E Especificações Página 114