RAD Data comm LA-210 Manual do Utilizador descarregar pdf (Página 72)

Chapter 3 Configuration Management User’s Manual

3-42 Setting the Operational Parameters RV-EMS/NGN LA-210

³ To map the QoS (Per Port):

1. Navigate to the Mapping dialog as explained above.

2. Select the desired bridge port and assign the desired traffic class (0–3) by

clicking <Traffic Class> and choosing a traffic class to each active bridge port.

Each traffic class can be assigned to more than one active bridge port.

³ To update the mapping dialog

• On the relevant QoS Mapping dialog, click <Refresh>.

The Mapping dialog is updated.

Configuring Fault Propagation

When the network > user fault propagation is enabled, the LAN ports are

deactivated when the PCS uplink becomes inactive. The Ethernet ports are re-

activated once the PCS port synchronization is restored.

When the user > network fault propagation is enabled, the PCS uplink is

deactivated when the LAN ports become inactive. The PCS uplink is restored once

the LAN ports are re-activated.

³ To enable the fault propagation:

1. In the LA-210 View window, select the System view.

2. On the menu bar, click Configuration > Fault Propagation.

The Fault Propagation dialog appears.

Figure

3-33. Fault Propagation

3. To enable Fault Propagation, check Activation and then click <Set>.

The fault propagation is active.

³ To disable the fault propagation:

1. Navigate to the Fault Propagation dialog as explained above.

2. Clear Activation and then click <Set>.

The fault propagation is inactive.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 157 158

Sem comentários

RAD Data comm LA-210 Manual do Utilizador Página 72