RAD Data comm E1 Especificações descarregar pdf (Página 69)

MiTOP-E1/T1 Ver. 1.0 Introduction 5-1

Chapter 5

Configuring a Typical

Application

This chapter provides detailed instructions for setting up a typical application

using a MiTOP-E1/T1 unit.

Configuration values shown in this chapter are examples only.

5.1 Introduction

This chapter explains how to configure a typical pseudowire application, using

MiTOP-E1/T1 delivering a full E1 stream to a central Gmux-2000 with GbE and

E1-PW/28 modules. MiTOP-E1/T1 is installed in the Fast Ethernet port of the

ETX-550 aggregator.

Figure

5-1. Typical Pseudowire Application

The order of the configuration steps detailed below is optional. You can configure

the three devices used in the sample application in any suitable order.

1. Configuring MiTOP-E1/T1:

a. Setting host IP parameters

b. Configuring E1 at the physical level

c. Defining the pseudowire peer

d. Configuring the general and service parameters of the pseudowire

connection.

Note

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 117 118

Sem comentários

RAD Data comm E1 Especificações Página 69