RAD Data comm E1 Especificações descarregar pdf (Página 37)

Installation and Operation Manual Chapter 2 Installation and Setup

MiTOP-E1/T1 Ver. 1.0 Installing MiTOP-E1/T1 in the Host Unit 2-3

Figure

2-2. SFP-CA Configuration Unit

³ To eject MiTOP-E1/T1 from SFP-CA:

1. Close all relevant management applications.

2. Push the release button at the front of MiTOP-E1/T1 to disconnect it from

SFP-CA.

3. Remove MiTOP-E1/T1 from the SFP socket on SFP-CA.

2.6 Installing MiTOP-E1/T1 in the Host Unit

You do not have to switch off the host unit when inserting or extracting

MiTOP-E1/T1.

³ To insert MiTOP-E1/T1:

1. Configure MiTOP-E1/T1 to the normal operation mode.

2. Insert MiTOP-E1/T1 into a free SFP (MSA-compatible) socket of the host

equipment.

3. Press MiTOP-E1/T1 firmly into the MSA SFP port connector.

MiTOP-E1/T1 is ready to operate.

³ To eject MiTOP-E1/T1:

1. Disconnect cables attached to MiTOP-E1/T1.

2. Push the release button at the front of MiTOP-E1/T1 to extract it from the

edge connector.

3. Remove MiTOP-E1/T1 from the socket.

Note

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 117 118

Sem comentários

RAD Data comm E1 Especificações Página 37