RAD Data comm FLM-1 Especificações Página 26

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 25
Chapter 3 - Operation FLM-1
Installation & Operation Manual
3-2 Operating Instructions 09/01/01 4:29 PM
Table 3-1 lists the functions of the FLM-1 indicators and switches.
Table 3-1 FLM-1 Indicators and Switches
Identification
No
Name Type Function
1 POWER LED Indicator
(green)
Lights up when the unit is powered.
2 TEST LED Indicator
(yellow)
Lights up when either local or remote unit is
performing a loopback test.
3 SYNC LOSS -
LOCAL
LED Indicator
(red)
Lights up when synchronization is lost at the local
unit.
4 SYNC LOSS -
REMOTE
LED Indicator
(red)
Lights up when synchronization is lost at the
remote unit.
5 LLB Push button When pressed (pushed in), the unit performs a
local loopback.
6 RLB Push button When pressed (pushed in), the unit performs a
remote loopback.
Note
Pressing LLB and RLB simultaneously has no effect; the unit just continues to
operate normally.
3.3 Operating Instructions
Power Turn-On
To apply AC power to FLM-1, connect its power cord to an acceptable AC
source. The POWER LED should light up. If the local and remote FLM-1
units are in operation and properly connected via the main channel, no
other indicator should be ON. If it is not so, refer to Chapter 4 for
troubleshooting information.
Operation
FLM-1 operates entirely unattended except when performing system tests.
Power Turn-Off
To turn off FLM-1, simply remove the AC power cord from the AC source.
Operational Field
Strapping
Changes
If it becomes necessary to reconfigure FLM-1 for twelve-channel mode or
six-channel mode operation, follow the appropriate setup procedure
described in Section 2.4.
Warning
Access to the inside of the equipment is permitted only to authorized
and qualified service personnel.
Vista de página 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Comentários a estes Manuais

Sem comentários