RAD Data comm MBE10-8D Manual do Utilizador descarregar pdf (Página 6)

SPECIFICATIONS

LAN INTERFACE

n n Standard

Conforms to Ethernet/IEEE 802.3

n n Type

AUI, BNC and UTP

LINK INTERFACE

n n Interfaces/Connectors

– V.24/RS-232 or RS-530 with

25-pin D-type, female

– V.35 with 34-pin female

– V.36/RS-422 with 37-pin

D-type, female

– X.21 with 15-pin D-type,

female

– Basic Rate ISDN with RJ-45

using S or U interface

– CSU/DSU with RJ-45

– 4-wire with 5-screw terminal

block

n n Protocol

Synchronous: HDLC based

Asynchronous: Programmable

UART

n n Data Rates

– V.24/RS-232:

Asynchronous: 2.4 to

115.2 kbps;

Synchronous: up to 64 kbps

– V.35, X.21, V.36, RS-530: up

to 1.5 Mbps

– 4-wire: from 16 to 768 kbps

(selectable, internal clock)

– DDS: Up to 56 kbps

CONTROL INTERFACE

n n Type

V.24/RS-232

n n Connector

RJ-45

n n Data Rate

2.4 to 19.2 kbps, 8 bits,

No parity, automatic rate

detection

GENERAL

n n Indicators

Power

ON the unit is powered on

Ready

ON packets can be

transferred

Main

ON the unit is configured

as local

Remote

ON the unit is configured

as remote

LAN TX

ON a packet is being

transmitted to the LAN

LAN RX

ON a packet is being

received from the LAN

LAN ERR

ON the LAN interface

indicates an error

Link TX*

ON a packet is being

transmitted to the link

BLINKS (every 15 seconds)

ISDN is connected and

the ISDN link is open

Link RX*

ON a packet is being

received from the link

BLINKS (every 15 seconds)

ISDN is connected and

the ISDN link is open

Link ERR*

ON ISDN is not connected

BLINKS the serial LINK interface

indicates an error

* Refers to both Link 1 and Link 2 in dual link

n n Panel Controls

Reset (front panel)

Power ON/OFF (rear panel)

n n Power

100-230 VAC

47-63 Hz, 10 VA max

n n Physical

Height: 4.4 cm / 1.8 in (1U)

Length: 30.0 cm / 11.8 in

Width: 21.6 cm / 8.5 in

Weight: 2.1 kg / 4.7 lb

n n Environment

Temperature: 0-50°C (32-122°F)

Humidity: Up to 90%,

non-condensing

ORDERING

MBE10-1/+/*

MBE10-8/+/*

Single link

MBE10-1D/+/*

MBE10-8D/+/*

Dual-link

MBE10-1D/$/+/*

MBE10-8D/$/+/*

Dual-link, over ISDN

+ Specify link interface:

(Note: for ISDN, this is the second interface.)

DDS for CSU/DSU

V24 for V.24/RS-232

V35 for V.35

V36 for V.36 or RS-449/RS-422

X21 for X.21

530 for RS-530

V35V24 for V.35/V.24

(MBE10-1D or MBE10-8D only)

(not valid for IBE options)

4W for 4-wire (built-in modem)

(not valid for IBE options)

* Specify LAN interface:

AUI for 10Base5

BNC for 10Base2

UTP for 10BaseT

$ Specify ISDN interface:

IBE for "S" interface

IBU for "U" interface

RM-19

Hardware for mounting one or two

units in a 19" rack

Specifications are subject to change without prior notice.



1997 RAD Data Communications Ltd.

572-100-06/97

1 2 3 4 5 6

Comentários a estes Manuais

Sem comentários