RAD Data comm HCD-E1 Especificações Página 107
- Página / 150
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
LRS-24 Installation and Operation Manual Appendix D CM-2 Management Commands
Defining LRS-24 And CM-2 SNMP Agent Parameters D-5
3. Press <Tab> to move to the next field.
4. Continue until all the required lines have been filled in.
SNMP community names are case-sensitive.
5. Press <Enter> to load all the data appearing on the screen into the CM-2
memory.
A typical data form is shown in Figure D-2.
LRS HUB SETUP
HUB NAME : 'name'
HUB NUMBER : '1234'
HUB LOCATION IS : 'location'
CONTACT PERSON IS : 'person'
CM CARD SOFTWARE VER : 0.0 MAIN CARD HW REV : VER 2.0
INTERFACE CARD HW REV: 0.0
TIME (HH:MM:SS) : 16:18:37 DATE : 2000-05-23
IP ADDR : 192.114.24.30 IP MASK : 255.255.255.0
READ COMMUNITY : PUBLIC
TRAP COMMUNITY : PUBLIC
READ/WRITE COMMUNITY : PUBLIC
DEFAULT GATEWAY : 000.000.000.000
BURN IN MAC ADDRESS : 9920D2FE838D BOOTP ON/OFF : OFF
BOOTP TIME OUT : 1 SEC BOOTP RETRIES : 30
HUB IP MODE : MULTIPLE
SERIAL LINE PROTOCOL : RS232
STATION CLOCK : INTERNAL CLOCK
Figure D-2. LRS Hub Setup
Command Fields
Table D-2 describes fields on the data form.
Table D-2. DEF HUB Command Fields
Field Name Description Options
HUB NAME Logical name assigned to the LRS-24 unit. Maximum 10 alphanumeric
characters
Default: LRS-24
HUB NUMBER LRS-24 management number. The two least
significant digits are displayed on the STAT/ADD
display located on the front panel of the CM-2
module.
Mmaximum four hexadecimal
digits
Default: 5544
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com
- Version 3.00 1
- Warranty 3
- Safety Warnings 4
- Telecommunication Safety 4
- Regulatory Information 5
- Declaration of Conformity 6
- Quick Start Guide 7
- 2. LRS-24 with CM-2 Module 8
- Contents 9
- Table of Contents 10
- List of Figures 11
- List of Tables 12
- Chapter 1 13
- Introduction 13
- Management/CM-2 functions 14
- Versions 15
- Application 15
- Features 16
- Overview 1-5 17
- 1.2 Physical Description 18
- Rear View 19
- Front View 19
- LRS-24B Rear Section 20
- LRS-24 Front Section 20
- LRS-24F ETSI UNIT 21
- LRS-24F Enclosure 21
- LRS-24 Module Slots 22
- 1.3 Functional Description 23
- Common Logic Modules 24
- Management 25
- 1.4 Technical Specifications 26
- External Clock Interface 27
- CM-1 Management Interface 27
- CM-2 Management Interface 27
- Physical Data 28
- Environment 28
- Chapter 2 29
- Installation and Setup 29
- 2-2 Introduction 30
- LRS-24B FRONT VIEW 31
- WITHOUT MODULES 31
- LRS-24B TOP VIEW 31
- LRS-24B SIDE VIEW 31
- AC Power 32
- DC Power 32
- Grounding 32
- 2.3 Unpacking the Chassis 33
- 2.4 Installation and Setup 34
- Installation and Setup 2-7 35
- CM-1 Module 36
- Installation and Setup 2-9 37
- Internal Jumpers 38
- Installation and Setup 2-11 39
- CM-2 Module 40
- 2-14 Installation and Setup 42
- CM-2 Installation 43
- PS Interface Modules 44
- LRSI-F-CM1 45
- Interface Module Installation 46
- LED Color Indication 47
- LINK Link Connection is made 47
- Connect Minor 48
- Alarm Relay 48
- LRSI-F-1-CM2 Installation 49
- LRSI-F-2-CM2 10B2 Front Panel 49
- LRSI-F-2-CM2 50
- LRS-24 Enclosure 52
- AC Power Connection 53
- DC Power Connection 53
- Dry Contact Alarm Connections 54
- Management Connections 54
- Station Clock Connections 54
- LRS-24 with CM-1 Module 55
- LRS-24 with CM-2 Module 56
- Normal Indications 57
- Power Off 57
- Troubleshooting 57
- Chapter 3 59
- Management via the CM-1 59
- 3.2 Hardware Requirements 60
- Supervision 61
- Terminal 61
- Configuring the Terminal 62
- DEF TERM 63
- NODE nn DEF SP 63
- NODE nn DEF PWD 63
- Chapter 4 65
- Management via the CM-2 65
- CM-2 Functions 66
- Introduction 4-3 67
- Management Priorities 68
- Initializing CM-2 69
- 4.2 Hardware Requirements 70
- Terminal Connection Methods 71
- 4-8 Hardware Requirements 72
- Hardware Requirements 4-9 73
- 4-10 Hardware Requirements 74
- Command Language Syntax 75
- Command Protocol 75
- Index of Commands 76
- BY PASS PASS WORD 78
- Chapter 5 81
- Troubleshooting and 81
- Diagnostics 81
- Status/Address 82
- Table 5-2. Error Messages 83
- 5-4 Error Messages 84
- Appendix A 85
- Connector Wiring 85
- A.7 Power Connectors 88
- Appendix B 89
- LRS-PS-FEED Power Supply 89
- B.3 Site Requirements 90
- Front Clearance 91
- Ambient Requirements 91
- Preparation for Installation 92
- Rack Installation 93
- Power Connection 93
- Operation 93
- Appendix C 95
- SNMP Management 95
- MIB Structure 96
- Management Domains Under SNMP 97
- C.3 IP Environment 98
- IP Environment C-5 99
- Net and Subnet Masks 100
- Assignment of Addresses 100
- Default Gateway 100
- C.4 SNMP Traps 101
- C-8 SNMP Traps 102
- Commands 103
- Appendix D 103
- CM-2 Management 103
- Procedure 104
- Command Fields 105
- Order from: Cutter Networks 108
- 1, 2, 3, 4, 6, 8, 10, 15, 20 109
- CM2 Download via LAN 112
- CM2 Download via XMODEM 113
- CM2 Download via CM2 FLASH 113
- Change CM-2 Software Version 113
- View CM-2 Software Version 114
- Modem Download via LAN 116
- Modem Download via XMODEM 116
- Modem Download via CM2 FLASH 116
- Changing Modem Version 118
- D.6 Viewing Modem Version 119
- Purpose 125
- Editing the Configuration 127
- Hub Configuration Operations 128
- Editing a Modem File 129
- Sending Configuration Files 133
- Display Format 136
- D-36 Displaying System Status 138
- Displaying System Status D-37 139
- D.16 Displaying Alarms Log 140
- D.18 Define CM-2 Reset 142
- D.19 Define Password 142
Manuais e produtos relacionados com Redes RAD Data comm HCD-E1
Redes RAD Data comm FCD-V35 Manual do Utilizador
(4 páginas)
(4 páginas)
Redes RAD Data comm FOMi-T1 Manual do Utilizador
(6 páginas)
(6 páginas)
Redes RAD Data comm MiRICi-E3T3 Especificações
(106 páginas)
(106 páginas)
Redes RAD Data comm 100 Especificações
(9 páginas)
(9 páginas)
Redes RAD Data comm ASM-60 Especificações
(90 páginas)
(90 páginas)
Redes RAD Data comm ASM-10/8 Especificações
(56 páginas)
(56 páginas)
Redes RAD Data comm ASMi-52CQ Especificações
(100 páginas)
(100 páginas)
Redes RAD Data comm FOM-E3 Manual de Instruções
(33 páginas)
(33 páginas)
Redes RAD Data comm 146 Manual do Utilizador
(202 páginas)
(202 páginas)
Redes RAD Data comm LA-210 Especificações
(210 páginas)
(210 páginas)
Redes RAD Data comm FOMi-T1 Especificações
(58 páginas)
(58 páginas)
Redes RAD Data comm T1 Especificações
(158 páginas)
(158 páginas)
Redes RAD Data comm HCD-E1 Especificações
(232 páginas)
(232 páginas)
Redes RAD Data comm FCD-X21 Manual de Instalação
(224 páginas)
(224 páginas)
Redes RAD Data comm LA-210 Manual do Utilizador
(158 páginas)
(158 páginas)
Redes RAD Data comm ASMI-450 Manual do Utilizador
(160 páginas)
(160 páginas)
Redes RAD Data comm FOM-40 Especificações
(74 páginas)
(74 páginas)
Redes RAD Data comm LRS-24 Especificações
(76 páginas)
(76 páginas)
Redes RAD Data comm RICi-622GE Especificações
(184 páginas)
(184 páginas)
Teledyne Above ground pool accessories user manuals
The list of Teledyne Above ground pool accessories products contains 2 user manuals for 2 models. All pdf user’s guides are available for download or viewing online.
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.093 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais