RAD Data comm FCD-IP Manual do Utilizador descarregar pdf (Página 72)

Chapter 3 Port Management RADview FCD-IP User’s Manual

3-34 Configuring Network Parameters

3.5 Configuring Network Parameters

RADview enables you to set IP addresses, IP routing protocol and DHCP Relay

parameters for the selected interface or DLCI.

Configuring IP Addresses



To set an IP Address:

1. Select the required interface.

2. Select Configuration >Network Parameters > IP Addresses…

The IP Address Table dialog box appears. The IP Address Table dialog box

varies depending on the selected link or DLCI. The parameters of the

different dialog boxes are provided below.

Figure 3-24. IP Address

Table 3-22. IP Address Parameters

Parameter Possible Values / Remarks

Interface The selected interface.

For ISDN there are two tabs: Channel 1 and Channel 2.

IP Address The WAN/LAN IP Address.

IP Mask The IP Address mask.

Interface The selected interface.

DLCI# Specifies DLCI number.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 109 110

Sem comentários

RAD Data comm FCD-IP Manual do Utilizador Página 72